69 research outputs found
Direct ultrafast laser written C-band waveguide amplifier in Er-doped chalcogenide glass
This paper reports the fabrication and characterization of an ultrafast laser written Er-doped chalcogenide glass buried waveguide amplifier; Er-doped GeGaS glass has been synthesized by the vacuum sealed melt quenching technique. Waveguides have been fabricated inside the 4 mm long sample by direct ultrafast laser writing. The total passive fiber-to-fiber insertion loss is 2.58 +/- 0.02 dB at 1600 nm, including a propagation loss of 1.6 +/- 0.3 dB. Active characterization shows a relative gain of 2.524 +/- 0.002 dB/cm and 1.359 +/- 0.005 dB/cm at 1541 nm and 1550 nm respectively, for a pump power of 500 mW at a wavelength of 980 nm. (C) 2012 Optical Society of Americ
Three-dimensional microstructuring of yttrium aluminum garnet crystals for laser active optofluidic applications
The following article appeared in Applied Physics Letters 103.4 (2013): 041101 and may be found at http://scitation.aip.org/content/aip/journal/apl/103/4/10.1063/1.4816338We demonstrate three-dimensional microstructuring in a neodymium doped yttrium aluminum garnet (Nd:YAG) crystal. Spatially well-defined hollow microstructures deeply embedded within the material are shown to result from the creation of a pre-damage state within the Nd:YAG crystal network that is validated using luminescence and Raman analyses of the structures. This opens up the potential of fabricating next-generation optofluidic devices in optical gain materialsFinancial support from the Spanish Ministerio de Educación under the Programa de Movilidad de Recursos Humanos del Plan Nacional de IþDþi 2008/2011 for abroad postdoctoral researchers. This work was also supported by the Universidad Autónoma de Madrid and Comunidad Autónoma de Madrid (Project S2009/MAT- 1756) and by the Spanish Ministerio de Educación y Ciencia (MAT2010-16161
Nanoindentation studies on waveguides inscribed in chalcogenide glasses using ultrafast laser
Optical straight waveguides are inscribed in GeGaS and GeGaSSb glasses using a high repetition-rate sub-picosecond laser. The mechanical properties of the glasses in the inscribed regions, which have undergone photo induced changes, have been evaluated by using the nanoindentation technique. Results show that the hardness and elastic modulus of the photo-modified glasses are significantly lower as compared to the other locations in the waveguide, which tend to be similar to those of the unexposed areas. The observed mechanical effects are found to correlate well with the optical properties of the waveguides. Further, based on the results, the minimum threshold values of hardness and elastic modulus for the particular propagation mode of the waveguide (single or multi), has been established
Evaluation of interface microstructure for friction stir welded aluminium-stainless steel plate
In the present study, commercially pure aluminium has been joined with 304 stainless steel by friction stir welding. Microstructural characterization was carried out using scanning and transmission electron microscopes. Diffusion of Fe, Cr and Ni is substantial within Al; however diffusion of Al within 304SS is limited. Owing to inter-diffusion of chemical species across the bond line, discrete islands of Fe3Al intermetallic phase forms within the reaction zone. The rubbing action of tool over the butting edge of 304SS removed fine particles of 304SS and got embedded in the stirring zone of Al matrix. At the latter stage austenite underwent phase transformation to ferrite due to large strain within its grain. Fracture path mainly moves through stirring zone of Al alloy under tensile loading; however in some places, presence of Fe3Al compound has been found
Evanescent-wave coupled right angled buried waveguide: Applications in carbon nanotube mode-locking
In this paper we present a simple but powerful subgraph sampling primitive
that is applicable in a variety of computational models including dynamic graph
streams (where the input graph is defined by a sequence of edge/hyperedge
insertions and deletions) and distributed systems such as MapReduce. In the
case of dynamic graph streams, we use this primitive to prove the following
results:
-- Matching: First, there exists an space algorithm that
returns an exact maximum matching on the assumption the cardinality is at most
. The best previous algorithm used space where is the
number of vertices in the graph and we prove our result is optimal up to
logarithmic factors. Our algorithm has update time. Second,
there exists an space algorithm that returns an
-approximation for matchings of arbitrary size. (Assadi et al. (2015)
showed that this was optimal and independently and concurrently established the
same upper bound.) We generalize both results for weighted matching. Third,
there exists an space algorithm that returns a constant
approximation in graphs with bounded arboricity.
-- Vertex Cover and Hitting Set: There exists an space
algorithm that solves the minimum hitting set problem where is the
cardinality of the input sets and is an upper bound on the size of the
minimum hitting set. We prove this is optimal up to logarithmic factors. Our
algorithm has update time. The case corresponds to minimum
vertex cover.
Finally, we consider a larger family of parameterized problems (including
-matching, disjoint paths, vertex coloring among others) for which our
subgraph sampling primitive yields fast, small-space dynamic graph stream
algorithms. We then show lower bounds for natural problems outside this family
- …